9. Never attempt to insert wires, pins or other such objects into the vents or
opening of the unit.
10. Disconnect device warning: Mains plug is used as the connection, so it
should always remain ready operate.
11. Batteries shall not be exposed to excessive heat such as sunshine, re or
the like.
12. Class 1LED product.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
POWER SUPPLY & BATTERY BACK-UP SYSTEM
Plug the AC power cord to a household outlet AC source. This unit is equipped
with a battery back-up system, it requires a 3V CR2032 at lithium battery
(not included). Insert the battery in the battery compartment, making certain
that the positive and negative (+ and -) battery terminals are attached to the
corresponding terminals on the plate in the battery compartment. If an AC power
failure occurs, the clock automatically switches to the battery power supply, the
clock and timer memory continue running. When the AC power resumes, the
clock switches back to AC again.
10
To Next Page
Loading...
Need help?
General
