Akai ACP-64

- Converted the projection time or temperature, keep depressed over 2
seconds to enter PROJECTION TIME 180° FLIP/TIME-TEMPERATURE
button (6).
Note: The time must be projected on the wall or on the ceiling of a darkened
room. The distance range for the clock projection is between 0.90m ~ 2.70m.
7. RESET
If the system does not respond or exhibits erratic or intermittent operation, you
may have experienced an electrostatic discharge (ESD) or a power surge that
triggered the internal microcontroller to shut down automatically. If this occurs,
simply disconnect the ac power cord and remove the system backup battery,
wait at least 3 minutes and then setup the unit again by following the manual.
SPECIFICATIONS
Model Reference • ACP-64
Power supply • AC 230 V ~ 50 Hz
Power consomption • 5 W
Standby mode consomption • <1 W
Battery back up • 3V (CR2032 Flat Lithium battery x 1)
Radio Frequency coverage • FM: 87.5MHz - 108 MHz
Audio output power • 150 MW
Product weight • 0.423 g
Product Dimensions • 121×121×68 mm
Indoor temperature range • 0 to +50°C or 32 to 122°F
IMPORTANT:
Due to continual revision and improvement on our products design,
specications are subject to change without further notice.
16