Akai AM-M459

Recording
Before beginning
@ Turn on all the components.
@ |fusing a DAT deck for recording, set it for analog recording.
STEREO INTEGRATED AMPLIFER AM-M459
wwreuess rewore concn svorem Al
MOTOR DRIVE VOLUME CONTROL
Select a recording source with the input select buttons as
follows:
To record from a record.............600- Lansehe Press PHONO.
To record from an FM or AM broadcast ..Press TUNER.
Compact disc recording.............seeeee Press CD.
To record from a DAT cassette or video
CASSCUE a sici les cadesen cheesesasuss ages teacceesasst sess Press DAT/
VCR.
2
Set
the
amplifier
to
the
normal
playback
mode.
Set
the
SOURCE
DIRECT
button
to
the
proper
position,
and
ad-
just
the
volume
with
the
VOLUME
control.
3 Prepare for recording and playback.
4
Adjust
the
recording
level
of
the
cassette
deck
and
begin
recording.
During recording
@ Donottouch the input select buttons as this willinterfere with
recording.
@ During recording, the VOLUME control, BALANCE control
and MUTE button can be used. If you wish to adjust the tone,
set the SOURCE DIRECT button to OFF before recording.
The signals being recorded will not be affected by these ad-
justments.
Notes for tape dubbing
Normally use the double cassette deck’s dubbing feature.
However, dubbing can also be performed as follows:
1 Connect a cassette deck or DAT deck for playback to the
DAT/VCR jacks, and a cassette deck or DAT deck for re-
cording to the TAPE jacks.
2 Press the DAT/VCR button of the amplifier.
3 Play back the original tape on the cassette deck connected
to the DAT/VCR jacks and record on the deck connected
to the TAPE jacks.