Akai AM-M459

Turntable
Tuner
CD player
LINE OUT
Cassette deck
Left channet
Speaker system
Speaker connections
On the speaker system
@ Use speakers with 8 to 16 ohms impedance only. Refer to
the marking on the amplifier’s rear panel.
@ Besure to connect the @ terminals of the speaker system to
the ® SPEAKERS terminals of the amplifier and © terminals
to the © SPEAKERS terminals of the amplifier.
®@ Connect the left speaker to the L SPEAKERS terminals of
the amplifier and the right speaker to the R-SPEAKERS
terminals of the amplifier.
To prevent fire or damage, only connect speakers of 8 to
16 OHM impedance to this unit.
10-En
How to connect
Strip off approximately 1 cm length of the vinyl covering
from the end of the speaker cords and twist the cord firmly.
While depressing the tab of the speaker terminal to its
open position, fully insert the speaker wire into the open
terminal.
Release the tab to connect the wire. Pull the wire gently to
make sure that it is securely connected.
1 2,3
—+} tom j—
After all connections have been made
Connect the power cords to an optional audio timer or directly to
your household AC outlets.
Important
The illustrated power plugs and cords are intended for —
general reference. The power plug and cord used in your
country may differ from the illustration. (Example U.K.,
Australia, U.S.A., Europe etc.) 95-En