Akai AM-M570

Recording
Before beginning
@ Turn on all the components.
@ If using a DAT for recording, set it for analog recording.
STEREO INTEGRATED AMPLIFIER AM-M570
POWER
1 Select a recording source with the input select buttons as
follows:
To record from a record .................. Press PHONO.
To record from an FM or
AM broadcast ..................cceceeees Press TUNER.
To record from a compact disc ......... Press CD.
To record from a DAT cassette or
video cassette ............cccceceeee eee Press DAT/VCR.
Set the amplifier to the normal playback mode. Set the
SOURCE DIRECT button to the proper position, and ad-
just the volume with the VOLUME control.
3 Prepare for recording and playback.
4 Adjust the recording level of the cassette deck and begin
recording.
During recording
@ Do not touch the input select buttons as this will interfere
with recording.
@ During recording, the VOLUME control, BASS and TREBLE
tone controls, BALANCE control and MUTE button can be
used. If you wish to adjust the tone, set the SOURCE DI-
RECT button to OFF before recording. The signals being
recorded will not be affected by these adjustments.
Notes for tape dubbing
Normally use the double cassette deck’s dubbing feature.
However, dubbing can also be performed as follows:
1 Connect a cassette deck or DAT for playback to the DAT/
VCR jacks, and a cassette deck or DAT for recording to
the TAPE jacks.
2? Press the DAT/VCR button of the amplifier.
Play back the original tape on the cassette deck con-
nected to the DAT/VCR jacks and record on the deck
connected to the TAPE jacks.