Akai AP-M600 - Page 3

@ Dust Cover Hinge
© 45 rpm Adaptor and Holder
@ Lead-in Adjustment Screw Hole
For adjusting the starting point during
_ automatic playback.
© Arm Lifter Height Adjustment
Screw Hole
@ Finger Lever
@ Arm Lifter Control Lever (¥/¥)
For up and down control of the tone
armiifler,
@ START/CUT Button (</ — )
To start and stop playback.
@ Cartridge —
@ Tone Arm Rest and Lock
Holds and locks the tone arm.
@ Plastic Platter
@® Rubber mat
® Spindle
@® SPEED Button( m 33/ = 45)
To select the playback speed.
@® Record Size Sensing Cams and
Slots
senses the record anc its size (30 cm
or 17 cm) for automatic playback.
In case of trouble, etc. necessitating dismantling, please dis-
2G mantle in the order shown in the photographs. Reassemble in
reverse order.
1. Removal of DUST COVER, RUBBER MAT and PLAT-
TER ee
RUBBER MAT
PLAITER
Befor Removing the
PLATTER, Remove the
DRIVE BELT as shown
below.
PLATTER
seasee ttn
2.
Removal
of
BOTTOM
COVER
~
BOTTOM COVER
3. Removal of MECHANISM BLOCK
MECHANISM
REMOVE
FHIS
LINKAGES
SERVICE MANUAL