Akai AT-93/L

On the RESET button
When the tuner does not fuction properly due to in-
terference caused by static electricity, etc., press
the RESET button located on the rear panel with
the blunt end of a pen or pencil, for example. (The
tuner must be on.)
Afterwards, the tuner will be set to the following ini-
tial modes:
• Antenna
• IFBAND
• HI-CUT
• MUTING
• FM mode
• SCAN MODE
• Tuning band
• Tuning frequency
• Memorized preset
stations
A
NARROW
On
On
FM AUTO
MANU
FM
87.5 MHz
All cancelled
After the RESET button has been pressed, it will be
necessary to memorize
all broadcast stations once
again.
6 RESET
Problem? Let's check
~----------------~10
Only noise is heard during AM (MW and LW)
or FM reception
The antenna is not properly connected.
For good reception, always connect an antenna
appropriate for your area.
The frequency will not change when a
PRESET STATION button is pressed
There is nothing memorized at that PRESET
STATION button.
Memorize a station.
The station is
not received clearly
The antenna is incorrectly oriented or insuffi-
cient for good reception.
For good reception, the antenna must be orient-
ed properly and be capable of catching as many
signals as possible.
Sequential station call tuning will not function
properly
The sequential station call function is not en-
gaged.
Set the 10/20 PRESET STATION button to 20
before turning off the power.
Make sure you have memorized stations at
PRESET STATION buttons 20, 19, and 1 8.
The preset station changes automatically
when the power is turned on
The
SEQUENTIAL STATION CALL function is
engaged.
Press one of the PRESET STATION buttons be-
tween 1 and 17 before turning off the power.
Tuner does not function properly
The microcomputer is malfunctioning.
Press the
RESET button on the rear panel of the
tuner.
Should a problem persist, write down the model
and serial numbers and all pertinent data regarding
warranty coverage as well as a clear description of
the exisiting trouble. Then contact your nearest au-
thorized Akai Service Station.