Akai CS-703D

Eee
Step Adjustment Test Tape Mode Adjustment Recult Raiarks
Item Supply Signal Point |
1 Playback level 333 Hz, 0 VU PLAY VR2 —5.5 +0.5 dBm
adjustment Test Tape 50 kB 410 mV
seceol P
VU Meter
taed 333 Hz,0 VU VR8 0 VU
2 sensitivity PLAY meee
: Test Tape 5 kB indication
adjustment
Playback 10 KH VRI
3 equalizer is PLAY ~20.0 +0.5 dBm
: Test Tape 5 kB
adjustment
Rec peaking Aa KHE Ll Meron (Refer to NOTE 6
4 : from an REC AC voltmeter .
adjustment : 3.3 mH pias i and Figs. 13, 14)
oscillator indication
Low Noise
LN Position Blank tape 1,000 Hz to
frequency 1,000 Hz, VR4 10,000 Hz
2 response 10,000 Hz, REC/PLAY 100 kB flat
adjustment -25.5 dBm response
recording
}___ 4 4
CrO
CrO, 7
Position Blank tape, 1,000 fe eo Set tape selector to
1,000 Hz VR6 10,000.Hz
6 frequency REC/PLAY CrQ,.
10,000 Hz, 5 kB flat
response (Refer to NOTE 7)
; —25.5 dBm response
adjustment f
recording
Fe-Cr Fees
Position Bink taps 1,000 Hz to Set tape selector to
1,000 Hz, VRS 10,000 Hz
7 frequency REC/PLAY Fe-Cr.
10,000 Hz 10 kB flat
response (Refer to NOTE 7)
: —25.5 dBm response
adjustment :
recording
Low Noise
Recording Blank tape, abies
8 level 1,000 Hz, REC/PLAY ae vy 7 3 nn
adjustment —5.5 dBm =
il. recording
Distortion 1,000 Hz ea Sone ee ao
9 Factor -5.5dBm_ | REC/PLAY en) (Refer to NOTE 8)
Confirmation recording IDes, Leesan 20%
Fe-Cr: Less than 2.0%
2 : F FLI Minimum Recording volume
10 ee Bue e St REC D07-002 AC voltmeter to maximum.
d nP (ORG) indication _| (Refer to NOTE 10)
19 kHz 19 kHz FL2 Minimum
11 filter from an REC DO7-00 AC voltmeter oa) nO
adjustment oscillator (BLK) | indication :
Chart-2
19