Akai EWV2000 - Parameter Editing - Vibrato and Breath Controls; Vibrato Effects on VCO, VCF, VCA; Breath Control Parameters

MODEL: EWV2000
002 Subject: To improve performance
no. MS-UU17
*o output MIDI Note On velocity data, the systen, software program has been
Ranged. Accordingly, the ROM IC version has been changed to V1.3.
Note:
IC version can be checked by holding "EDIT" and "BACKWARD"
buttons depressed then turning the unit on.
The LCD displays the ROM IC version as follows.
Version
VI.2 :
VI. 3 :
LCD Display
Ver-1 26-AUG-87
Ver-1 08-OCT-87
Release the buttons to resume normal operation.
Operational Instruction :
After turning EWV2000 on, depress "MIDI" button 4 times then the following
will be shown on LC Display.
CPT:00 VELO: 00
"CPT- is the abbreviation of Capture time and it is the time duration which
chi maximum level is detected. "VELO" is the abbreviation of Velocity and
the MIDI velocity output value (1 to 127) is displayed here.
SLOW RISING
m
FAST RISING
-THRESHOLD
TIME
Set -CPT- value from 01 to 10 depending on the rising time of breath
envelope. The rising time will be changed by the adjustment of BRE
control knobs on Front Panel and the way EVI or EWI controller is played,
A longer capture time allows the accurate detection of velocity but it
makes MIDI NOTE ON output delayed. Adjust "CPT- value while observing
velocity date.
- 2 -
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html