Akai EWV2000 Manual

IS- VIB/BEND: With this button, the vibrato (VCO), PWM, growl
(VCF), and tremolo (VCA) effects can be set for each voice. Also,
(he bend width for each voice can be set within a maximum range of
±700 cents.
CHORD: This is a special function which makes it possible to play an
external MIDI compatible sound source in polyphonic.
SAVE: Used to save voice data onto a tape.
Qh BREATH INTENSITY: With this button, the breath sensor effect
can be set for each voice.
VERIFY: Used to check whether data has been properly saved onto
a tape,
fj}- EFFECT: This button contains modes for selecting the trigger (sin-
gle/multi) for triggering the envelope generator and one of the three
fitters for processing voices.
LABEL: Used to give names or labels to voices you have created.
LOAD: Used to load data which has been saved onto a tape.
LINE OUT: Line Output Jack and Output Level Knob
The output jack is a 06.3mm standard phone plug jack.
Connect it to the line input jack on a mixer or amplifier. Usually set the
output level knob between the 8 and 10 position.
EXT IN: External Sound Source Input Jack and Input Level Knob
The input jack is a (£6.3 mm standard phone plug jack.
Connect it to the line output jack on an external synthesizer or digital sam
pler. EXT IN is used with source 1. Usually set the input level knob be
tween the center and the 10 position, and adjust the output level of the syn
thesizer or digital sampler so that the sound is input with no distortion.
adjust the output level of the synthesizer or digital sampler so
that the sound is input with no distortion.
1-2. REAR PANEL
\KUIIK IIIK ( 4
© LT3
AKAI
professional
Fig. 1-2
(D TAPE IN/OUT: Cassette Tape Recorder Input/Output Jacks
Use these jacks when saving or loading voice data onto or from a
cassette tape. Connect with mini plug cords.
(D MEMORY PROTECT: Memory Protect Switch
This switch is used to protect the memory banks. Set to OFF when
writing voice data, or when loading or verifying data on a tape. Oth
erwise, keep in the ON position.
(D MIDI OUT: MIDI Output Terminal
Use this terminal when you want to control another MIDI compo
nent (synthesizer or keyboard) or a MIDI sampler with the
EWIlOOOorEVMOOO.
® POWER INLET: Power Inlet
Only use the included power cord.
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html

Akai EWV2000 Specifications

General

Brand	Akai
Model	EWV2000
Category	Recording Equipment
Language	English