Akai GX-F25

Il. TECHNICAL DATA
TRACK SYSTEM
4 Track 2 channel stereo system
TAPE
Philips type cassette
TAPE SPEED
4.76 cm/s#1.0% (1-7/8 ips. +1.0%)
HEADS
Erase head x1
Twin field super GX head for record/playback x 1
MOTORS
Electronically speed controlled D.C. motor for capstan drive x 1
D.C. motor for reel drive x 1
WOW & FLUTTER
Less than 0.04% WRMS, 0.11% (DIN 45 500)
TAPE WINDING TIME
80 sec. using a C-60 cassette tape
FREQUENCY RESPONSE
LN: 30 to 15,000 Hz
+3 dB (—20 VU)
30 to 16,000 Hz
+3 dB (-20 VU)
30 to 16,500 Hz
+3 dB (—20 VU)
30 to 9,000 Hz
+3 dB (0 VU)
30 to 19,000 Hz
+3 dB (—20 VU)
30 to 13,000 Hz
+3 dB (O VU)
LH:
CrO,:
Metal:
SIGNAL TO NOISE RATIO
LN:
LH:
Better than 58 dB
Better than 58 dB
CrO,: Better than 60 dB
Metal: Better than 60 dB
(measured via tape with peak recording level)
Dolby NR switch ON: Improves up to 10 dB above 5 kHz
HARMONIC DISTORTION LN: Less than 0.8%
INPUT
LH: Less than 0.8%
CrO,: Less than 0.7%
Metal: Less than 0.7%
MIC: 0.25 mV (input impedance 5.0 kohms)
Required microphone impedance: 600 ohms
Line: 70 mV (input impedance 47 kohms)
OUTPUT
Line: 410 mV at 0 VU
Required load impedance: more than 20 kohms
Phone: 100 mV/8 ohms at 0 VU
DIN
Input: 2 mV (input impedance 10 kohms)
Output: 410 mV
Required load impedance: more than 20 kohms
POWER REQUIREMENTS
100 V, 50/60 Hz for JPN
120 V, 60 Hz for USA and Canada
220 V, 50 Hz for Europe except UK
240 V, 50 Hz for UK and Australia
110/120/220/240 V, 50/60 Hz internally switchable for other
countries.
POWER CONSUMPTION
—-
JPN 20 W
AAL, CSA, U/T 22 W
DIMENSIONS
440 (W) x 118 (H) x 285 (D) mm (17.3 x 4.6 x 11.2”)
WEIGHT
+
6.8 kg (15.0 Ibs)
* For improvement purpose, specifications and design are subject to change without notice.
* “Dolby” and the Double D system are trademarks of Dolby Laboratories (Manufactured under license from Dol by
Laboratories).