Akai GX-F25

V. VOLTAGE AND CYCLE CONVERSION
REAR PANEL POWER SUPPLY PCB
al NW AA N
Fig. 4 Voltage Conversion (U/T Model only)
1. VOLTAGE CONVERSION
Models for Canada, Europe, USA, UK, Australia and
Japan are not equipped with this facility.
Each machine is preset at the factory accorling to
destination, but some machines can be set tol10 V,
120 V, 220 V or 240 V as required.
If voltage change is necessary, this can be accomplish-
ed as follows:
1. Disconnect power cord.
2. Loosen holding screws and remove upper cover.
3. Remove short pin plug from present holesand re-
place in correct holes.
Follow the markings explicitly.
2. CYCLE CONVERSION
With DC motor, cycle conversion is not necessiry —