Akai GXC-704D

I TECHNICAL DATA
1. MODEL CS-703D
TRACK SYSTEM
~y
4 track, 2 channel stereo system
TAPE
Philips type cassette tape
TAPE SPEED
WOW AND FLUTTER
‘| 4.76 cm/s 2% (1-7/8 ips +2%)
Less than 0.06% WRMS, 0.16% (DIN 45500)
FREQUENCY RESPONSE
40 to 13,000 Hz +3 dB using LN tape
40 to 15,000 Hz +3 dB using CrO, (SA) tape
DISTORTION (1,000 Hz “0” VU)
Less than 1.3% using LN tape
Less than 2.0% using CrO, (SA) tape
SIGNAL TO NOISE RATIO
ERASE RATIO
Better than 54 dB using LN tape
Better than 56 dB using CrO, (SA) tape
(measured via tape with peak recording level)
Dolby NR switch ON: Improves up to 10 dB above 5 kHz
Better than 65 dB
BIAS FREQUENCY
85 kHz
HEADS
(2): One recording/play back head, one erase head
MOTOR
(1): Electronically speed controlled DC Motor
FAST FORWARD AND REWIND TIME
120 sec using a C-60 cassette tape
OUTPUT JACKS
Line (2): 410 mV (0 VU)
Required load impedance: more than 20 kohms
Phone (1): 50 mV/8 ohms
INPUT JACKS
DIN JACK
POWER REQUIREMENTS
DIMENSION |
WEIGHT
Microphone (2): 0.25 mV (Input impedance 5.0 kohms)
Required microphone impedance: 600 ohms
Line (2): 70 mV (Input impedance 100 kohms)
Input: 0.25 mV (Input impedance 2.2 kohms)
Output: 410 mV
Required load impedance: more than 20 kohms
100V, 50/60 Hz for JPN
120V, 60 Hz for U.S.A. and Canada
220V, 50 Hz for European countries except UK
240V, 50 Hz for UK and Australia
110/120/220/240V (Switchable), 50/60 Hz for the other countries
380(W) x 150(H) x 266(D) mm
(15.0 x 5.9 x 10.5")
5.1 kg (11.2 Ibs)
* 6.0 kg (13.2 Ibs) AAL Model only
* For improvement purposes, specifications and design are subject to change without notice.
* “Dolby”? and the Double D symbol are trademarks of Dolby Laboratories.
(Manufactured under license from Dolby Laboratories).