Akai GXC-704D

2. MODEL GXC-704D
TRACK SYSTEM | 4 track, 2 channel stereo system
TAPE Philips type cassette
TAPE SPEED 4.76 cm/s +1% (1-7/8 ips +1%)
WOW & FLUTTER
Less than 0.05% WRMS, 0.14% (DIN 45500)
FREQUENCY RESPONSE
35 to 14,000 Hz +3 dB using LN tape
35 to 14,000 Hz +3 dB using LH tape
35 to 15,000 Hz +3 dB using CrO, (SA) tape
35 to 15,000 Hz +3 dB using FeCr tape
DISTORTION (1,000 Hz 0 VU)
Less than 1.3% using LN tape
Less than 1.3% using LH tape
Less than 2.0% using CrO, (SA) tape
Less than 2.0% using FeCr tape
SIGNAL TO NOISE RATIO
Better than 54 dB using LN tape
Better than 54 dB using LH tape
Better than 56 dB using CrO, (SA) tape
Better than 56 dB using FeCr tape
(measured via tape with peak recording level)
Dolby NR switch ON: Improves up to 10 dB above 5 kHz
ERASE RATIO
Better than 65 dB
BIAS FREQUENCY
85 kHz
HEADS
MOTOR
FAST FORWARD AND REWIND TIME
OUTPUT JACKS
INPUT JACKS
DIN JACK
POWER REQUIREMENTS
DIMENSIONS
(2): One GX recording/playback head, one erase head
(1): Electronically speed controlled DC motor
120 sec. using a C-60 cassette tape ;
Line: 410 mV (0 VU). Required load impedance; More than 20 kohms
Phone: 100 mV/8 ohms
Microphone: 0.25 mV (Input impedance 5.0 kohms).
Required microphone impedance: 600 ohms
Line: 70 mV (Input impedance 100 kohms)
Input: 0.25 mV (Input impedance 2.2 kohms)
Output: 410 mV. Required load impedance; More than 20 kohms
100V, 50/60 Hz for JPN
120V/60 Hz for U.S.A. & Canada
220V/50 Hz for European Countries except UK
240V/50 Hz for UK & Australia
110/120/220/240V (Switchable), 50/60 Hz for the other countries
WEIGHT
380(W) x 150(H) x 295(D) mm, (15.0x5.9x11.6"')
5.2 kg (11.4 Ibs), *6.1 kg (13.4 Ibs) AAL Model only
* For improvement purposes, specifications and design are subject to change without notice.
* “Dolby” and the Double D symbol are trade marks of Dolby Laboratories.
(Manufactured under license from Dolby Laboratories).