Akai head rush e2

Application
Change the number of Heads
If you connect a plug to any head (HEAD 1 - 4),
the delay sound of the HEAD does not get
routed through the MIX output. For example, if
you connect the plugs to HEAD 3 & 4, only the
delay sound from HEAD 1 & 2 gets routed
through the MIX output.
So you can mute unnecessary delay sounds
by connecting plugs to the HEADs.
Sound on Sound
This allows you to mix the direct signal (your playing sound) and the delay signal, create a harmony part, and add
your solo and your backing sounds to the mix.
Example setting
1. Turn the FEEDBACK, HF DAMP, HEAD GAP, and RATIO fully counter-clockwise.
2. Set the LEVEL to the maximum position by turning it fully clockwise.
3. Select the number of Heads.
E.g. In the case you want to get the delay sounds with one beat later, if you use only HEAD 1-3, you can
get just the delay of one bar. (4 beats). In this case, you should connect a plug to HEAD 4 and mute the
delay sound of HEAD 4.
4. Set the delay time by tapping the right Footswitch so the delay time matches the rhythm.
5. Turn the effect ON by tapping the left Footswitch and play your guitar. You can get three separate delay
sounds after you play.
Sending out separate delay sound and direct sound using multiple amplifiers.
This allows the delay sounds and the direct sound to sound separately by connecting the MIX output and HEAD
1-4 outputs to each amplifier.
E2HEADRUSHOperator'sManual
                                              
                                              
6