Akai head rush e2

Connecting E2 to External device
The diagram below demonstrates how you can connect the E2 to external devices.
Please note that this is just one example, so when you actually connect your devices, refer to the
device's operator's manual.
Note : You can also connect multiple outputs of the E2 to multiple guitar amplifiers and the direct(dry) sound and
effect(wet) sound can be amplified separately. Refer to the Normal Delay Application (page 4) and the Tape
Echo Application (page 6) for the details.
Basic Operation
Selecting mode
Pressing the MODE SELECT button changes the mode and the selected mode LED lights up.
Selecting mode with Footswitches
You can change the mode by pressing the two footswitches simultaneously. Now you can change modes with
your foot while playing your guitar.
E2HEADRUSHOperator'sManual
                                              
                                              
3