TAPE ECHO mode
Basic Operation
1. Select TAPE ECHO mode by pressing the
MODE SELECT switch.
Note: You can also change the mode by
pressing the two Footswitches simultaneously.
2. Set the delay time by tapping the right
Footswitch (TAP TEMPO) twice.
The delay time is calculated based on the
tempo of the two taps. The right red LED (TAP
TEMPO) flashes in time with the delay time.
The maximum delay time is 5.9 seconds.
3. Tap the left Footswitch (ON/OFF), and the left
green LED (ON/OFF) lights, indicating the
effect is on. Tap it again and the effect is off.
Hint: You can change the delay time by tapping the right Footswitch while the effect is on.
Fine setting
In the TAPE ECHO mode, only the controls with blue lettering can be used.
LEVEL : Adjusts the output level of the effect sound.
HF DAMP : Decreases the amount of high frequency in the effect sound. Turning it to the right decreases the
amount of high frequency and makes the sound like a classic analog delay effect.
FEEDBACK : Adjusts the amount of feedback in the delay sound (Adjusts the number of repeats.) Turning it to
the right increases the number of repeats.
TIME : Adjusts the delay time. Use this to adjust shorter delay times that are difficult to set by tapping
the Footswitch. The range of the delay time available with this control is between 10 ms and 1.45
seconds. Use the Footswitch if you want to set delay times longer than 1.45 seconds.
RATIO : Adjusts the output ratio of the four Heads. Turning it to the left makes the output ratio of the four
Heads equal, turning it to the right sets it so the output level of HEAD 1 remains high and HEAD
2-4 gradually decrease in level.
HEAD GAP : Adjusts the interval between the four virtual Heads. Turning it to the left creates the same interval
between each of the four Heads, turning it to the right creates a different interval between each of
the four Heads. Using a combination of HEAD GAP, FEEDBACK, and RATIO adjustments it's
possible to get a Random Delay Effect.
To Next Page
Loading...
