Akai head rush e2

NORMAL DELAY mode
Basic Operation
1. Select NORMAL DELAY mode by pressing the MODE SELECT switch.
You can also change the mode by pressing the two footswitches simultaneously.
2. Set the delay time by tapping the right
footswitch (TAP TEMPO) twice.
The delay time is set from the tempo of the two
taps. The red LED on the right side(TAP
TEMPO) flashes in time with the delay tempo.
The maximum delay time is 23.8 seconds.
3. Tap the left footswitch (ON/OFF), and the
green LED on the left side(ON/OFF) lights and
the effect is switched on. Tap it again, and the
effect is switched off.
Hint: You can change the delay time by tapping the right Footswitch while the effect is on.
Fine setting
In the NORMAL DELAY mode, only controls with yellow letters can be used.
LEVEL: Adjusts the output level of the effect sound.
HF DAMP: Decreases the amount of high frequency in the effect signal. Turning it to the right decreases
the amount of high frequency and makes the sound like a classic analog delay effect.
FEEDBACK: Adjusts the amount of feedback of the delay sound (Adjusts the number of repeats.) Turning it
to the right increases the number of repeats.
TIME COARSE: This is a course adjustment of the delay time. It's used to adjust shorter delay times. The range
of the delay time with this control is between 0.5ms and 1.45 seconds. Use the Footswitch if
you want to set the delay time longer than 1.45 seconds.
TIME FINE: This is a fine adjustment of the delay time set by the TIME COARSE.
Application
Sending out the delay sound
and the direct sound
separately using two
amplifiers.
This allows the delay sound and the
direct sound to be heard separately by
connecting the MIX output to one
amplifier, and the EFFECT output to a
separate amplifier.
E2HEADRUSHOperator'sManual
                                              
                                              
4