9. TIME COARSE/TIME
TIME COARSE provides a coarse adjustment of the delay time between 0.5ms and 1.45 seconds during the
NORMAL DELAY mode. TIME adjusts the delay time between 10ms and 1.45 seconds during TAPE ECHO
mode. This is not used in LOOPING REC mode.
10. TIME FINE/HEAD GAP
TIME FINE provides a fine adjustment of the delay time when using the NORMAL DELAY mode.
HEAD GAP adjusts the position of the virtual tape heads when using the TAPE ECHO mode.
This is not used in LOOPING REC mode.
11. RATIO
This adjusts the output ratio of the HEAD 1 - 4 outputs when using the TAPE ECHO mode. This is not used on
NORMAL DELAY or LOOPING REC mode.
12. MODE SELECT switch
This allows you to select the
TAPE ECHO, NORMAL DELAY
or LOOPING REC mode.
13. MODE LED
The LED of the selected mode will
light.
14. LOOP LEVEL switch
This selects either fixed (FIX) or
variable (VARI) output level of
looped playback when using
LOOPING REC mode.
This is not used on NORMAL DELAY
or TAPE ECHO mode.
15. LOOP TIME switch
This selects the maximum record
time when using LOOPING REC
mode.
This is not used on NORMAL DELAY
or TAPE ECHO mode.
16. ON/OFF, PLAY/STOP LED
This will light while the effect is active (ON) when using NORMAL DELAY or TAPE ECHO mode.
This will light during Looping Playback, when using LOOPING REC mode.
17. TAP TEMPO, REC/OVER DUB LED
This flashes in time with the delay tempo when using NORMAL DELAY or TAPE ECHO mode.
This will light while loop recording/over-dubbing when using LOOPING REC mode.
18. ON/OFF, PLAY/STOP switch
This turns the effect ON or OFF by tapping it during NORMAL DELAY or TAPE ECHO mode.
This also turns the loop playback to start or to stop during LOOPING REC mode.
19. TAP TEMPO, REC/OVER switch
This sets the delay time by tapping it twice during NORMAL DELAY or TAPE ECHO mode.
This also turns the loop recording/over-dubbing on during LOOPING REC mode.