4
MPC2500 Quick Manual
Playing back several sequence in a series
There are two ways to play back several sequences in a series. You can either select the sequence to be played in real time, or
set the order of the sequences in SONG mode.
Selecting the sequences in real time
01. In the Sq field in the MAIN page, select the sequence you wish to play first.
02. Press the [PLAY START] key to start the play back of the sequence.
03. Select the Sq field during play back, and select the next sequence to play.
Selecting a sequence in the Sq field during the playback brings up the Next field, where you can select the next
sequence. After playing back the currently selected sequence to the end, the MPC2500 will start playing back the
sequence you select in the Next field. By repeating this step, you can play back several sequences continuously.
Playing back the sequences in the selected order
To play back the sequences in the selected order, use the SONG mode.
01. Press the [MODE] key and then the [PAD 16] (SONG).
This brings up the SONG page, where you can set the order of the sequences to be played.
02. In the Song field, select a song whose name is (unused).
03. Move the cursor to (end of song) and select the sequence to play first using the DATA wheel.
04.
Select the (end of song) field by pressing the down cursor key, and select the sequence that you want played back next.
Assign the sequences in the desired order by repeating the steps 3. and 4.
05. Press the [PLAY START] key.
The assigned sequence will be played in the selected order.
Tips : For more information about the SONG mode, see the “Chapter 7 : Song mode” section of the operator's manual. (on page 42)
To Next Page
Loading...
Need help?
General
