10
Edit Mode
In Edit Mode, you can edit the settings of the currently selected Preset. The
settings vary depending on the controller you are editing and are listed in the
Appendix: Mode Parameters section. Please note that the changes you make
will only apply to the currently selected Preset.
To navigate Edit Mode:
1. Press Edit to enter Edit Mode.
2. Select a control to edit (pad, button, etc.) by moving or pressing it. The selected control
and its editable parameters will appear in the display.
3. In each page of Edit Mode:
• Use the Up Cursor and Down Cursor buttons to move through the parameters on
the current page.
• If there are multiple pages (indicated by Pg1, Pg2, etc.), use the Left Cursor and
Right Cursor buttons to move between different pages.
• Turn the Value Dial to change the currently selected value/setting.
4. To edit more controls, repeat Steps 2–3.
To return to a normal performance mode, press Preset.
Important: Save the Preset to retain your edits. Without saving, these changes will be lost if
you load a new Preset. See the Preset Mode section to learn how save your Preset.
Each section of this chapter is dedicated to a specific control and lists its editable parameters.
For an overview of the available controls and parameters, see the Appendix: Mode
Parameters section.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
