16
What is Control Change?
Control Change refers to the use of MIDI
Continuous Controller data. Continuous Controller
(CC) data are MIDI messages capable of
transmitting a range of values (0-127) and are
often used for controlling volume, pan and other
parameters on your DAW or sound module.
What is Aftertouch?
Aftertouch refers to MIDI information sent when
pressure is applied to a pad after it has been
struck, and while it is being held down. Aftertouch
is often used to control volume, vibrato and other
parameters. On the MPK25, the knobs can also
be assigned to transmit Aftertouch information.
SELECT EVENT TYPE IN THIS
FIELD.
EDITING KNOBS
The knobs on the MPK25 are controllers which can be set to transmit Control Change or Aftertouch
information. In addition, the knobs may also be assigned as an Increment/Decrement function. Their default
operation is to transmit Control Change information when used.
1. Press [EDIT] button to enter EDIT MODE.
2. Turn the knob which you would like to edit.
3. On Page 1, turn the [VALUE] dial to select ‘CTRL
CHANGE’ (Control Change) or ‘AFTERTOUCH’ as the
event type.
4. Press [ENTER] to view Page 2.
Depending on which event type you select on Page 1,
parameter options on Page 2 will be changed.
5. Use [<] and [>] buttons to move through fields on the
second page.
The parameter fields available for each event type are
outlined in the following pages.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
