23
ARP TYPE
ARP TYPE
RANGE
BUTTON
MODE
ARPEGGIO PARAMETERS – TYPE, RANGE, BUTTON MODE
The following parameters can be edited by selecting “TYP RNG TGL” on Page 1.
ARP TYPE
Select one of the following arpeggio types in this field – Up, Down, Incl, Excl,
Rand, Chrd.
1. While in Arp Type field, use [VALUE] dial to select Arp Type.
2. Use the [>] button to select the next field.
Arp Type descriptions:
UP – Notes arpeggiate from the lowest note to the highest note held.
DOWN – Notes arpeggiate from the highest note down to the lowest note.
INCL (Inclusive) – Notes arpeggiate from lowest to highest notes and back
down. Lowest and highest notes are retriggered at the direction change.
EXCL (Exclusive) – Notes arpeggiate from lowest to highest notes and back
down. Lowest and highest notes are not be retriggered at the direction change.
RAND (Random) – Plays held notes in random selection.
CHRD (Chord) – Repeats the held notes.
RANGE
Select the arpeggiator range in this field.
1. Use [<] or [>] buttons to select Range field.
2. While in Range field, use [VALUE] dial to select Range.
3. Use the [>] button to select the next field.
BUTTON MODE
In this field, you can select whether the [ARP ON/OFF] button will behave in a
momentary (MTY) fashion, where pressing the button will turn on the
Arpeggiator function and releasing it will turn it off, or in a toggle (TGL) manner,
where pressing the button turns on the Arpeggiator function and pressing again
turns it off.
1. Use [>] button to select Range field.
2. While in Range field, use [VALUE] dial to select Range.
3. Use the [>] button to select the next field.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
