15
After Sales Support 1300 886 649
5.1 Select the best location
1. To avoid vibration and noise, make sure the unit is installed securely and rmly.
2. Install the unit where the sunlight does not shine directly on the unit. If the unit
receives direct sunlight, build an awning to shade the cabinet.
3. There should be no obstacle, such as a fence or wall, within 50cm from the back
of the ambient because it will prevent heat radiation of the condenser.
4. Restriction of outside air will greatly reduce the cooling and heating eciency of
the air conditioner.
5. Install the unit on a slight angle so that an condensate formed will not enter the
room (about 10mm or 1/4 bubble with level).
6. Install the unit with its bottom portion 75~150cm above the oor level.
7. The power cord must be connected to an independent circuit. The yellow/green
wire must be grounded.
CAUTION
All side louvres of the cabinet must remain exposed to the outside of the structure.
5. Installation
To Next Page
Loading...
