Akai VS-G205

SHOWVIEW
timer
recording
(215EOH
only)
Initial setting
SHOWVIEW is a quick and easy way of setting your VCR for
timer
recording. All you have to do is enter a few numbers
(shown next to the TV programme in the TV magazine or
newspaper) into the remote control and the TV channel/date/
start/stop times are entered automatically.
Note:
e Make sure thatthe remote control and VCR's clocks are set
correctly before programming.
1
Press the SHOWVIEW button on the remote control.
Enter the code number of the TV programme that
you want to record with the 1 - 0 buttons.
Press the < button if you want to cancel the last number
that you entered, each time you press the button, the
number to the left will be cancelled.
To cancel the whole number, press the CANCEL button.
Press the OK button.
The programme date, start/stop time will be displayed.
“Err” will appear if anon recognizable code is entered. In
this case, re-enter the correct code.
lf the programme is on every day or once every week,
you can record it automatically by pressing the DAILY or
WEEKLY button.
Enter the PS number of the channel that the pro-
gramme is being shown on.
For example, the programme you want to record is on
LA2. If your VCR is set so that LA2 is on PS 2, then you
enter 0 then 2.
Pointthe remote control at the VCR and press the OK
button.
The data will be transferred to the VCR.
“FULL” will appear on the FL display if all 4 programmes
already have data entered. To change or cancel existing
data, refer to “NOTES ON TIMER RECORDING? at the
end of the “Timer recording” section.
Press the SHOWVIEW bution to return to the normal
mode.
Press the TIMER button.
The timer and I-HQ indicators will appear on the VCR’s
FL display. The VCR is now in the timer mode and recor-
ding will start and stop automatically at the programmed
time.
Note:
e The I-HQ feature works automatically during timer recor-
ding.
© lf the loaded video tape’s recording defeat tab has been
removed, the tape will automatically be ejected when the
TIMER buiton is pressed.
e |fatapeis not loaded, the VCR will not enter the timer mode
and will return to the normal mode. In this case, load a tape
and press the TIMER button again.
e Ifthe video tape runs out during timer recording, the VCR
will automatically eject the tape and turn itself off.
Step 4 only has to be performed once (for each preset
channel), as the remote control will memorize and auto-
matically enter the channel number the next time that a
code numberis entered for that channel (LA2in this case).
The following display will appear in place of that
shown in step 3, and step 4 can be omitted.
LA
‘
19:00-
ey 12" 3.
SHOWVIEW IS A TRADEMARK APPLIED FOR BY GEM-
STAR DEVELOPMENT CORP. SHOWVIEW SYSTEM IS
MANUFACTURED UNDER LICENSE FROM GEMSTAR
DEVELOPMENT CORPORATION.
23