Akai VS-G205

Timer recording
Up to four programmes can be programmed for recording, and Before proceeding
programming can be done up to one year in advance.
e Turn on the TV and VCR.
Only
programmes
on
preset
TV
stations
can
be
recorded
.¢
Make
sure
thatthe
VCR
and
remote
control
clocks
are
set.
using
timer recording.
If
you
have
not
already
preset
the
TV
|
®
Make
sure
that
a
tape
is
loaded.
stations,
refer to the
“Presetting
TV
stations” section.
There are three types of timer recording to choose from: 4 Set the start time minutes and stop time hour and
; minutes with the < , >, “\ and V buttons.
One time recording , When the / or \v button is pressed continuously, the
To record a programme that is only broadcast once. minutes will increase or decrease at 5 minute intervals.
Weekly recording
To record a programme that is broadcast once every week:
every monday (E-MON), every tuesday (E-TUES) etc.
Daily recording
To record a programme that is broadcast daily: MON-FRI or
MON-SUN.
5 Press the > button.
The date will flash.
Taeyele-latisalialem ohm cciiile) (mee lal ice)| 6 _ Setthe date for recording with the /\ or V buttons.
When the A button is pressed, the date will advance
If the LC display clock has not been set or shows the wrong until it reaches the same day of the next month, followed
time, set the clock before proceeding (refer to “Setting the by weekly recording (E-MON etc.) and then daily recor-
clock”). ding (MON-FRI/MON- SUN).
{ Press the PROG. button (211EOH). When the Y button is pressed the order will reverse.
Press the SHOWVIEW button twice (215EOH).
Set the start time hour with the “ or \ button.
“N\: Press to count up.
\v : Press to. count down.
Note:
e Numbers can be entered with the 1-0 buttons, in place of
the A and / buttons. Daily recording
To set a single digit number press 0 (zero) first, then press
the number. For example, to set 8:15; press (0) zero, then 8, hase the > button. ill fl
then 1, and then 5. e channel number will flash.
If you use the 1 - 0 buttons for data entry you do not need to
; Note:
ress the > button to sta xt data flashing. ‘ai
peste 2 io Sra hie next Gate hesnng © To set the month manually: from the PS position press the
Press the > button. < button and enter the month with the “\/\v buttons, then
The minutes will flash. continue from step 7.
8 Set the channel number with the “ or \ button.
25