Akai VS-G205

Press the OK button.
The transmit indicator and “OK’ will flash to indicate that
the programmed data is now ready to be transmitted.
' Note:
26
1
If you want to change data before transmitting, use the < or
> button toreach the data, anduse the “\or \/or 1-0 but-
tons to correct the data. Then press the OK button.
Point the remote control at the VCR’s remote sensor
window and press the OK button.
The programme data will be transmitted to the VCR and
the programme number (1-4) will appear on the FL dis-
lay.
“FULL” will appear on the FL display if all 4 programmes
already have data entered. To change or cancel existing
data, refer to “NOTES ON TIMER RECORDING’ at the
end of the “Timer recording” section.
| | Press the PROG. button (211EOH) to return the
remote control to the normal mode.
Press the SHOWVIEW button (215EOH) to return the
remote control to the normal mode.
| 2 Press the TIMER button.
The timer and I-HQ indicators will appear on the FL dis-
play. Unless released, the VCR will remain in the timer
mode until all timer recording is finished.
During the timer mode all other operations of the VCR
will be suspended (except for the clock) until the VCR is
released from the timer mode.
M@ To release the VCR from the timer mode, press the
TIMER button.
The TIMER indicator of the FL display will disappear, power
will come back on, and timer recording will be suspended. If
the VCR is released from the timer mode while timer recor-
ding is in progress, the VCR will continue to record until the
stop button is pressed or the video tape runs out.
@ Press the PROG.LIST button to review the programmes
and times on the FL display.
Note:
The I-HQ feature works automatically during timer recor-
ding.
If the loaded video tape’s recording defeat tab has been
removed, the tape will automatically be ejected when the
TIMER button is pressed.
If atape is not loaded, the VCR will not enter the timer mode
and will return to the normal mode. In this case, load a tape
and press the TIMER button again.
If the video tape runs out during timer recording, the VCR
will automatically eject the tape and turn itself off.