Akai VS-G205

28
The remote controi can also be used in the previous
operation (steps 1-18).
Press the PROG. button (on the VCR -211EOH) (on the
remote control or VCR - 215 EOH) then follow steps
2-18 using the remote control buttons instead of the
vcr.
Alternatively, the <, >, “or \ buttons can be used for
steps 2-16) </>: to move to the next or previous data.
/N: to increase the number.
\v : to decrease the number.
NOTES ON TIMER RECORDING
if data is not entered within five minutes of the display starting
to flash, all data will be cancelled and you will have to start from
the beginning again.
Cancelling timer recording:
if, at any time during programming, you want to cancel the pro-
gramme data, press and hold the VCR OK/CANCEL button for
afew seconds or press the remote control CANCEL button. All
the data will be cancelled.
If you want to cancel any programmes later on, press the
PROG.LIST button until you find the programme that you want
to cancel then press the OK/CANCEL button for a few sec-
onds until the data is cancelled.
Reviewing timer programmes:
If you want to review the programme dates, times or channel
numbers, press the PROG.LIST button to go through the pro-
grammes.
Each timer programme will be displayed (cyclically) on the FL
display each time that you press the button.
When a programme is displayed, you can alter any of the data
with the remote control’s A, \, < or > buttons (</> to go
to the data and “\/\ to change the data).
Timer mode:
When the VCR is in the timer mode (the timer display is lit on
the FL display) none of the other VCR functions (playback, rec-
ording etc.) can be used.
if you want to use the other functions, the VCR must be re-
leased from the timer mode. To do this, press the TIMER but-
ton until the timer display disappears from the FL display.