SP2/SP4/SP8/SP8-X20 Manual
Updated until firmware 476 - 2 -
1) Introduction
1. What is sensorProbe?
2. What’s the difference between SP2 SP4 and SP8?
3. What’s the difference between SP8 and SP8-X20?
4. How to use this manual
5. sensorProbe2
6. sensorProbe4 and sensorProbe8
7. sensorProbe8-X20
8. sensorProbe8-X20 20 Extra Dry Contact Inputs
2) Installation
1. Assigning an IP address
2. Testing your new IP address
3. Upgrading the firmware
3) Setting up a sensor and Downloading Sensor Data
1. Basic Setup
2. Downloading Sensor Data using Remote Syslog
4) Notifications
1. Setting up a trap
2. Setting up Email notifications NEW: Information on TLS/SSL
5) System Settings
1. Network Settings
2. System tab
6) Making your unit visible to the internet
7) Quick Facts and FAQ
To Next Page
Loading...
Need help?
General
