AKCP sensorProbe8 - Page 2

SP2/SP8/SP8-X20 Manual
Updated until firmware 413 - 2 -
1) Introduction
1. What is sensorProbe?
2. What’s the difference between SP2 and SP8?
3. What’s the difference between SP8 and SP8-X20?
4. How to use this manual
5. sensorProbe2
6. sensorProbe8
7. sensorProbe8-X20
8. sensorProbe8-X20 20 Extra Dry Contact Inputs
2) Installation
1. Assigning an IP address
2. Testing your new IP address
3. Upgrading the firmware
3) Setting up a sensor
1. Basic Setup
4) Notifications
1. Setting up a trap
2. Setting up Email notifications
5) System Settings
1. Network Settings
2. System tab
6) Making your unit visible to the internet
7) Quick Facts and FAQ