SP2/SP8/SP8-X20 Manual
Updated until firmware 413 - 24 -
On System Start Up - the time is synchronized once the cameraProbe8 is turned on or
reboot.
Once a Month/Week/Day/Hour - the time is automatically synchronized every month,
week, day, or an hour, respectively.
NTP Server 1 and 2 :- Set the IP address of the NTP servers to be used. The NTP will
synchronize the time with the server that has less number of the stratum.
2) System tab
From the systems tab you can input various settings for the unit. These settings are mostly
optional.
(continued on next page)
To get to the entry point of this tutorial complete the following :-
1) Point your browser to the units IP address
2) Log in as administrator using your admin password
3) From the summary page click on the “System” tab
To Next Page
Loading...
