To Next PageTo Next Page
Need help?Do you have a question about the AKG C 518 M and is the answer not in the manual?
General| Type | Condenser |
|---|---|
| Polar Pattern | Cardioid |
| Impedance | 200 Ohms |
| Connector | XLR |
| Voltage | 48 V |
| Power Requirements | Phantom power |
| Max SPL | 132 dB SPL |
| Recommended Load Impedance | 1 kOhm |
| Equivalent Noise Level | 22 dB-A |
| Sensitivity | -49 dBV (re 1 V/Pa) |
Ensure connected equipment meets local safety regulations and has a ground lead.
Verify all listed components are present; contact dealer if any are missing.
Refer to AKG website or MicroMic brochure for optional accessories like the B 29 L battery power supply.
Cardioid mic for high gain, drum miking. Features shock mount, 50mm gooseneck, and 135° swivel joint.
Description of C 518 M, including phantom power, 10-ft cable, and bass rolloff.
Description of C 518 ML, including battery/phantom power options and 5-ft cable.
Condenser microphone requires power. Use only AKG-recommended power supplies to avoid damage.
Connect C 518 M to XLR input with phantom power. Switch phantom power on.
Connect C 518 ML to B 29 L or MPA V L using mini XLR cable. Connector locks automatically.
Press connector's unlocking button before pulling cable to prevent damage.
Connect output socket to bodypack transmitter input socket using supplied cable. Mount adapter/transmitter to microphone.
Open clamp jaws with screw, hang microphone on drum hoop, and tighten screw.
Aim microphone at skin perimeter for tight sound, center for open sound, or use felt for dry sound.
Tips for small drums, stick clearance, bass rolloff, and adjusting gooseneck with stabilizer knee.
