12
2 Description
2.1 Introduction
Dear Customer:
Thank you for purchasing an AKG
product. This Manual contains important
instructions for setting up and operating
your equipment. Please take a few
minutes to read the instructions below
carefully before operating the equip-
ment. Please keep the Manual for future
reference. Have fun and impress your
audience!
2.2 Unpacking
Check that the package contains all the
parts listed above. If anything is missing,
please contact your AKG dealer.
2.3 Optional Accessories
W 880 foam windscreen
2.4 Description
The HT 40 handheld transmitter oper-
ates on one fixed, quartz stabilized fre-
quency in the 710 MHz to 865 MHz UHF
carrier frequency range and uses an
antenna integrated in the body.
The microphone element permanently
mounted on the transmitter is acousti-
cally identical to the D 880 vocal micro-
phone from AKG. This microphone fea-
tures a built-in wind and pop filter to
reduce wind and breath noise and pro-
vides low handling noise sensitivity, high
gain before feedback, and brilliant sound
quality.
2.5 Controls (See fig. 1 on page 13)
1 On/Off switch: This slide switch
provides three positions indicated
in the display window:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the
microphone element is muted
while power and the RF carrier
frequency remain on. This pre-
vents the receiver from respon-
ding to interference from other
transmitters.
OFF: Power to the transmitter is off.
2 Status LED: Indicates battery status.
LED flashes momentarily upon
switching ON and extinguishes:
batteries are OK.
LED lights constantly: batteries will
be dead in about 50 minutes.
3Color Code: The color of this plastic
clip indicates the carrier frequency of
your transmitter. Receivers tuned to
the same frequency are marked with
1 HT 40
Handheld
Transmitter
2 AA size
1.5 V dry
batteries
1 SA 43 stand
adapter,
black color
code clip
To Next Page
Loading...
