To Next PageTo Next Page
Need help?Do you have a question about the AKG SOLIDTUBE 2800Z0001 and is the answer not in the manual?
General| Type | Condenser |
|---|---|
| Polar Pattern | Cardioid |
| Frequency Response | 20 Hz - 20 kHz |
| Sensitivity | 20 mV/Pa (-34 dBV) |
| Output Impedance | 200 Ohms |
| Bass Cut Filter | 12 dB/octave at 100 Hz |
| Recommended Load Impedance | 1000 Ohms |
| Power Requirement | 48V Phantom Power |
| Preattenuation Pad | -10 dB |
| Output Connector | XLR |
Diagnosing hum when bass attenuator is active or when mic body is touched.
Troubleshooting loose contacts, wiring, or cable issues causing intermittent audio.
Checking varistors and mains transformer for issues causing repeated fuse blowouts.
Addressing high hum voltage at the microphone output.
Troubleshooting intermittent operation, hum, or crackling noise issues.
Troubleshooting repeated fuse blowing in the power supply unit.
Detailed circuit diagrams for the SOLIDTUBE device.
Identification and voltage specifications for key test points.
Wiring diagrams for different microphone cable versions.
List of parts related to the device chassis, housing, and connectors.
List of electronic components including transistors, diodes, capacitors, and resistors.
Visual layout of components on the printed circuit board.
Comparison of wiring for former and recent versions of the device.
Detailed comparison of circuit diagrams for old and new versions.
Detailed list of parts for the microphone suspension system.
