AKG SOLIDTUBE User Manual

SOLIDTUBE
Bedienungshinweise
User Instructions
Mode d´emploi
Istruzioni d´uso
Modo de empleo
Instruções de utilização
For USA and Canada only:
Please observe the “Important Safety Instructions” on page 7!

AKG SOLIDTUBE Specifications

General

Type	Condenser
Polar Pattern	Cardioid
Frequency Response	20 Hz - 20 kHz
Output Impedance	200 Ohms
Preattenuation Pad	-10dB
Powering	48V Phantom Power
Recommended Load Impedance	1000 ohms
Signal to Noise Ratio	76 dB
Bass Cut Filter	12dB/octave
Sensitivity	20 mV/Pa (-34 dBV) ± 2dB
Max SPL	140dB SPL (with pad)
Equivalent Noise Level	18 dB-A (IEC 60268-4)

Summary

1. The Microphone

How is the tube replaced?

Detailed instructions for safely replacing the vacuum tube within the SOLIDTUBE microphone.

How is the microphone mounted?

Guidance on properly mounting the microphone onto stands using the included shockmount.

Powering the microphone

On the operation of the microphone

2. The N-SOLIDTUBE Power Supply Unit

PLEASE OBSERVE CLOSELY!

Critical safety warning regarding dangerous voltages within the power supply unit.

Before doing this, please remove the mains connection cable from the mains supply!

Procedure for safely replacing the fuse in the power supply unit, including voltage checks.

3. Technical Specifications