Akuvox R27 series - Page 6

Make a call:
Input the room number, press Dial key to make a call.
Receive a call:
R27X supports Auto Answer by default. Incoming calls will be answered
automatically
.
Unlock by DTMF:
During the call, press the corresponding DTMF code of answer unit to unlock R27X remotely.
Unlock by Private Key:
In the idle, enter “ # + password + # ” or “ password + # ” to open the door. (The latter is
used for New version. Go to web UI - Intercom - Basic - Display Type to switch Old or New
version UI.)
Unlock by RF Card(Optional):
Place the predefined RF Card in the RF reader area to open the door.
Opera
6
Configuraon
1.IP Address Checking: Press *2396# to enter administrator setting interface. Click System
Information to get the IP address. R27X uses DHCP by default.
2.Account Registration: On web UI, go to the path: Account -> Basic page to register
account and fill in the account information. ( Please refer to admin guide for more
information)
3.DTMF Code Configuration: On web UI, go to the path: Intercom -> Relay -> Relay
ID/DTMF and choose the DTMF code number in corresponding area.
AKUVOX (XIAMEN) NETWORKS CO., LTD.
ADD: 10/F, NO.56 GUANRI ROAD, SOFTWARE PARK II, XIAMEN 361009, CHINA
www.akuvox.com
Notice Information
Akuvox R27X firmware contains third-party open source software under the terms of the GNU General Public License(GPL).
Akuvox is committed to meeting the requirements of the GNU General Public License (GPL) and will make all required
source code available.
The source code of software under the terms of GNU GPL can be downloaded online:http://www.akuvox.com/gpl.
Information contained in this document is believed to be accurate and reliable at the time of printing. This document is
subject to change without notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com
© Copyright 2019 Akuvox Ltd. All rights reserved.