AKYAPAK ASM - Page 38

ASM
USER’S MANUEL
PAGE: 38
03.04-B1
9.4 SETTLE THE BENDING MATERIAL 22
9.5 BENDING OPERATION 22
9.6 THE MACHINE METOD FOR THE BENDING OF THE MATERIAL 23
9.7 BENDING OPERATION LINE OF THE MATERIAL 24
9.8 CONE BENDING 25
9.9 CONE BENDING POSITION LINE 26
9.10 THE LOW ROLL MATERIAL COMPESSION 27
9.11 TAKEN THE BENDING MATERIAL OUT OF THE MACHINE 27-28
9.12 ADJUSTMENT OF THE DIGITAL DISPLAY 28
10.MAINTENANCE 29
10.1 PROTACTION OF THE MAINTENANCE 29
10.2 REGULAR CLEANLINESS 29
10.3 CHECKING THE ABRASION PARTS IN THE MACHINE 29
10.4 REPAIRING THE FAILURE 29
11.TO GREASE 30
11.1 TO GREASE THE NEEDED POINTS 30
11.2 THE TABLE FOR THE GREASE COMPARISON 31
12.SPARE PARTS PLAN 32
12.1 SPARE PARTS PLAN 1 33
12.2 SPARE PARTS PLAN 2 34
12.3 SPARE PARTS PLAN 3 35
13. THE LABLE USING ON THE MACHINE
35-36
14.INDEX
15.ELECTRICAL PLAN
37-38