Need help?Do you have a question about the AKYAPAK ASM and is the answer not in the manual?
Declares conformity with relevant European standards and instructions.
Outlines warranty period, coverage, and exclusions for the machine.
Provides initial guidance on using the user manual for machine operation.
Lists technical specifications including dimensions, power, and capacity.
Illustrates the physical measurements and dimensions of the machine.
Describes machine equipment, safety factors, and identifies danger areas.
Details danger situations, operator protection, and risk management.
Explains machine functions and guidelines for setting up the machine's location.
Covers proper machine operation, risks from accessories, and emissions.
Addresses risk situations, operator requirements, and personal protection.
Details safety during assembly, warning factors, and immediate emergency procedures.
Provides a checklist for verifying protective elements and handling transportation damage.
Discusses machine protection measures and safe transport/raising procedures.
Details the ground assembly plan and essential knowledge for machine setup.
Covers environmental conditions and procedures for placing the machine on a scale.
Explains electrical connections and how to control the motor's rotation direction.
Details safety rope, switches, and general usage guidelines.
Describes safety switches, general usage guidelines, and circuit breaker functions.
Identifies and illustrates the components of the machine's control panel.
Provides general information on machine operation and factors affecting bending quality.
Details the process of setting up the bending material and initiating the bending operation.
Illustrates various methods for bending materials using the machine.
Describes the bending process line and common material defects like barrel mistake.
Explains the cone bending operation, its difficulty, and relevant calculation formulas.
Provides step-by-step instructions for setting up and performing cone bending.
Details the process for adjusting lower roll compression and removing bent material.
Explains how to adjust the digital display for precise bending operations.
Covers maintenance protection, regular cleaning, and procedures for repairing failures.
Illustrates grease application points and presents a table comparing grease types.
Lists and illustrates spare parts related to the upper rolls shaft.
Lists and illustrates spare parts related to the rear rolls shaft.
Lists and illustrates spare parts related to the bottom rolls shaft.
Displays labels for manufacturer, machine details, oil types, and lubrication.
Shows various warning and safety labels used on the machine.
To Next Page
General