ASM
USER’S MANUEL
PAGE: 25
03.04-B1
9.9. CONE BENDING POSITION LINE
At the cone bending operation the operation lines are determine below.
1-Loose the headless bolt(A)on the clutch shaft to obtain the require cone bending.(See form 1
below).
2-Pull the clutch (B)orientate the arrow direction.(See form 1 below).
3-Rotate the rear shaft arm(C ) and take up the rear shaft to the requiring dimension. z. The rear
shaft opposite end hold down according to the cone position.(Form 1).
4-According the requiring dimensions take the rear shaft up, put forward the clutch shaft and
tighten the headless bolt.(Form 1).
5-As development for the cutting and bending material ,on the body rest are present the cone
bending apparatus.(form 2)Tight the lower top roll and make the bending operation.
A
B
C
Cone Bending Apparatus
FORM-2
FORM-1
To Next Page
Loading...
