Shandong Huasheng Zhongtian Machinery Group Co., Ltd. Shandong Huasheng Zhongtian Engineering Machinery Co., Ltd.
Rotor assembly
Washer
Washer
Nut
Installatio
n: 1) Clear off the dirt, engine oil, grease and other foreign matter on tapering part and
ensure that the rotor magnet does not suck washers and foreign matter.
2) Mount the key C3×8 inside the crankshaft key slot.
3) Mount the flywheel onto the crankshaft.
4) Drop a little engine oil on crankshaft thread and stator fixing screws of
crankshaft to facilitate the screw installation.
5) Fasten the stator fixing screws as specified torque.
Note: Rotor may push the key out of the key slot. It is required to confirm it after installation.
4.6 Starter
4.7.1 Starter structure
18
To Next Page
Loading...
