AL-KO BKS 2625 T - User Manual

Questions and Answers

J
julierobertsonAug 11, 2025
Why AL-KO Chainsaw engine can't be started or switches off immediately?
- B
  blake61Aug 11, 2025
  If your AL-KO Chainsaw engine fails to start or shuts off quickly, it might be due to several reasons. You may be using an incorrect starting procedure, so refer to the "Starting the engine" instructions. The spark plug might be dirty or have an incorrect electrode gap, requiring a check as described in "Maintenance and storage". Another possibility is a blocked air filter; clean or replace it according to the "Maintenance and storage" guidelines. If the problem persists, there may be issues with the fuel mixture preparation.
M
Mr. Joshua WattsAug 17, 2025
What to do if AL-KO Chainsaw engine emits excessive smoke?
- J
  Joshua RossAug 17, 2025
  If your AL-KO Chainsaw engine is emitting excessive smoke, it's likely due to an incorrect fuel mixture. Prepare the fuel mixture as instructed in the "Mixture preparation and storage" section. If the problem persists, there may be other issues with the fuel mixture preparation.
F
fwardAug 22, 2025
Why AL-KO Chainsaw engine runs irregularly or does not develop any power under load?
- M
  Mallory WyattAug 22, 2025
  If the AL-KO Chainsaw engine runs irregularly or lacks power under load, the spark plug might be dirty or have an incorrect electrode gap. Check the spark plug as described in the "Maintenance and storage" section. If the issue continues, there may be problems with the fuel mixture preparation.
E
ellisamandaAug 28, 2025
Why AL-KO Chainsaw engine can be started, but only develops low power?
- W
  woodsgrantAug 28, 2025
  If your AL-KO Chainsaw engine starts but has low power, the air filter might be blocked. You should clean or replace the filter according to the instructions in the "Maintenance and storage" section. If the issue remains, it could be related to problems with the fuel mixture preparation.
G
gadamsSep 4, 2025
What to do if no oil comes out of AL-KO Chainsaw?
- E
  Erika CarrilloSep 4, 2025
  If no oil is coming out of your AL-KO Chainsaw, it could be due to low-quality oil. Empty the tank, flush the tank and lines with cleaning fluid, and change the oil. Alternatively, the lubricating holes may be blocked and need cleaning.