AL-KO Solo 636 - User Manual

Questions and Answers

M
Mr. Michael Singh PhDAug 11, 2025
Why my AL-KO Solo 636 engine will not start?
- F
  floresmarisaAug 11, 2025
  If your AL-KO Chainsaw engine won't start or stay running, it might be due to a few reasons. You may be using the wrong starting method, so double-check the instructions. The spark plug could be dirty or have the wrong gap, so inspect and clean it. A clogged air filter can also cause this, so clean or replace it. If none of these fix the issue, there could be a problem with the carburetor, and you should contact your dealer.
C
Colton PierceAug 17, 2025
Why is my AL-KO Solo 636 Chainsaw giving off excessive smoke?
- R
  rknightAug 17, 2025
  If your AL-KO Chainsaw is emitting excessive smoke, it could be due to an incorrect fuel mixture. Make sure you are preparing the fuel mixture according to the instructions. Another potential cause could be carburetion problems, in which case you should contact your dealer.
A
Aaron DavisAug 23, 2025
What to do if my AL-KO Solo 636 Chainsaw engine starts but is lacking in power?
- N
  Natalie AndersonAug 23, 2025
  If your AL-KO Chainsaw engine starts but lacks power, a clogged air filter could be the culprit. Try cleaning or replacing the filter. If the problem persists, it might be due to carburetion issues, and you should contact your dealer.
W
William CastilloAug 29, 2025
Why AL-KO Chainsaw engine runs irregularly and lacks power when revved?
- A
  amanda07Aug 29, 2025
  If your AL-KO Chainsaw engine runs irregularly and lacks power when revved, the spark plug might be dirty or have an incorrect electrode distance; check the spark plug. Alternatively, there may be carburetion problems, and you should contact your dealer.
K
Katelyn NicholsSep 4, 2025
What to do if my AL-KO Solo 636 Chainsaw releases no oil?
- B
  Brooke LopezSep 4, 2025
  If no oil is being released from your AL-KO Chainsaw, it could be due to bad quality oil. Empty the tank, clean it and the pipes with liquid detergent, and then change the oil. Another possibility is that the lubrication holes are clogged, so try cleaning them.