AL-KO Pro 700 V2 - Clean engine and silencer (07)

GB
32 AL-KO Pro 700 V2
Maintenance and care
NOTE
Contact our customer service if you can-
not carry out work yourself.
NOTE
The oil capacity for the AL-KO Pro 700
V2 engine is max. 2.0l.
NOTE
■
Drain off the old oil when the engine
is warm. Warm oil runs out quickly
and fully.
■
Dispose of used oil in an eco-friend-
ly manner!
1. To empty the fuel tank: Allow the engine to
run until it stops itself.
Or drain the fuel.
2. Remove the spark plug connector (04/1).
3. Place the container (06/1) for the old oil.
4. Unscrew the oil dipstick (06/2) and wipe it
clean.
5. Unscrew and remove the drain plug (06/3).
6. Allow the oil to run out completely into a con-
tainer.
7. Replace the drain plug. Ensure that the gas-
ket is correctly positioned. Tighten the drain
plug firmly.
8. Top up with clean oil through the dipstick
opening (see chapter 4.2.1 "Filling with en-
gine oil (02)", page28). Use a funnel (not in-
cluded with the engine).
9. Insert the dipstick up to the stop and then pull
out again. Check that the level has reached
the MAX (06/4) mark.
10. Insert oil dipstick and screw in tight.
11. Remove any spilled oil.
7.3 Clean engine and silencer (07)
WARNING!
Risk of fire due to for-
eign objects
Foreign objects on the en-
gine can cause the lawn
tractor to catch fire. A fire
can result in serious or
even fatal injuries.
■
Remove combustible
debris (e.g. grass,
leaves, grease) from the
engine, especially from
the exhaust and cylinder
area.
■
Check and clean the ex-
haust and cylinder area
regularly.
IMPORTANT!
Danger from water
Penetrating water (ignition
system, carburettor...) can
lead to malfunctions.
■
Do not spray the engine
with water.
1. Allow the engine to cool before cleaning.
2. Remove the contamination regularly from the
engine with a cleaning cloth or brush.
3. Blow-off all waste and dirt residues from the
silencer and its cover using compressed air.