The Wi-Fi Hub will not operate the garage door opener.
-Ensure the garage door opener is compatible.
-Try manually programming the Wi-Fi Hub to the garage door.
1) Press and release the BUTTON (Settings), the Blue LED will turn on solid.
2) Press and hold the BUTTON again until the Green and Yellow LEDs alternate blinking. Press and release the BUTTON again, the Yellow LED will turn
on solid.
3) Press and release BUTTON 1 the number of times indicated in the chart (the Yellow LED will turn on solid)
4) Press and release the BUTTON. The Yellow and Green LEDs will blink.
5) Press and release the LEARN button on the garage door opener.
6) Press and release BUTTON 1 until the garage door opener clicks. Press and release BUTTON 1 again to activate the garage door opener. If the garage
door opener does not activate, press and release the BUTTON, then repeat steps 3-6.
7) To exit programming mode, press and hold the BUTTON until the Blue LED blinks (if Wi-Fi is not set up) OR the Green LED turns on (Wi-Fi has already
been connected)
Erase Wi-Fi Settings from Wi-Fi Hub
Press and hold the BUTTON until the Blue LED blinks.
Erase Door Sensors from Wi-Fi Hub
Press and hold the BUTTON 1 or 2 that is connected to the door sensor until the Yellow LED turns off.
If you are still unable to resolve your issue, contact us at support@alarm.com.
To Next Page
Loading...
Need help?
General