13
• The primary function is printed directly on the key and is achieved with a short or longer
push on the regarded key
• The secondary function you can achieve by first pushing FC and afterwards the regarded
key. The printing for the secondary functions is directly next to the keys.
• The activated function will then be shown in the display.
Left side
SCH Special channel: short press: switch to the special channel respectively back again
to the manual channel selection MCH
SW Special- and normal (=manual) channel watch: first press FC, afterwards SCH
This function is some kind of dual watch. The radio is switching between the last
manual selected channel MCH and the special channel SCH, so you can watch both
channels. The watching stops as soon as there is some noise on one channel.
TOT Time-Out-Timer on/off: with switched on time-out-timer the transmitter turns of and
back to receiving, if the PTT button is pressed longer than 3 minutes
A/F type of modulation (AM or FM, if activated): with these key you can choose
between AM and FM. The type of modulation will be displayed. The FM radios for
Austria do not have any function on this key.
CH9 direct dialing key: switches at the push of this button from the last selected channel
directly to channel 9 and back. Channel 9 is the international call- and emergency
channel: especially in Germany this means: on this channel there are many
stations listening. In case of an emergency there are great chances to be heard on
this channel. Also for calling other stations, from which you know they are listenting
to channel 9, you can start a call there. Call the desired station. As soon as you got
someone from this station, agree on another channel and move there, so that
channel 9 is free again for other calls. Of course such an emergency channel only
works if there are enough stations who listen. So try to listen to this channel as
much as possible – this direct key helps you. With the next time pushing the CH9
key your radio switches to your last used channel.
This channel is used by nearly all truckers also on AM.
M1-M3 select memory channel: press FC, afterwards press M1, M2 or M3
Change memory channel: choose a channel, press FC and afterwards press M1,
M2 or M3 a little bit longer. The memory channels are perfect to save often used
channels.
ASQ automatic squelch on/off (look at the chapter about the automatic squelch on page
11)
Right side
FC Function key: This key switches other keys on their secondary functions. To use
the secondary functions press FC and afterwards the key with the secondary
function you want (printed next to the keys).
SC SCAN on/off: press SC longer than 3 seconds, release. Now the scanning of all
channels starts. Here all channels are scanned one after another. When the scan
function recognizes a busy channel the scan stops for some seconds so that you
To Next Page
