9
Operation
Programming the country-settings
Your CB radio can always be switched between 6 different country versions. To switch you need to
hold one or two buttons on the front side while you turn on the radio with the VOL/ON (volume and
on-/off). Afterwards you release the pressed button(s). The programmed country code is saved as
long as you programm another country code or until the device is disconnected from the power
supply.
The factory setting, with which your device after connecting to 12 V starts, may be differently for
delivery in specific countries.
When first turned on, radios sold in Germany will start with the AM/FM programming:
• dE 80/40: 80 channels FM and 40 channels AM. The pre-programmed channel is channel
9 in AM, so the device starts directly on the international trucker- and emergency channel.
Shortly after turning on the device “dE” is displayed.
This programming is only allowed in Germany and Czech Republic and must not be used in any
other country (in the Czech Republic only FM is allowed).
• EU 40/40: 40 channels FM and 40 channels AM. The pre-programmed channel here is also
channel 9 in AM, so the device starts directly on the international trucker- and emergency
channel. Shortly after turning on the device “EU” (for Europe) is displayed.
This programming is provided for Belgium, Germany, Estonia, Switzerland (with Liechtenstein),
Finland, France, Ireland, Italy, Latvia, the Netherlands, Poland, Portugal, Spain and Slovakia. For
Poland we also have a special programming (see further below), where the frequencies are 5 kHz
displaced downwards, as it was in the old Poland standard. For Spain there is also a special
programming with 4 Watt AM. This and the Poland switch position may only be used in these
countries.
• EC 40 FM: 40 channels FM (past CEPT setting)
Squelch
Receive Volume
On-Off
Rotary control
Channel
SCH – TOT - AM/FM –
Channel 9
6 pin MIC socket
LCD Channel &
Status Display
FC – BP – TSQ - ASQ
To Next Page
Loading...
