To access the Auto Channel Scan menu, press the Function Button (#12) until the auto
channel icon blinks and SC appears in the LCD Panel (#8).
Press the Up Button (#10) or the Down Button (#11) to choose scanning up or down from
the current channel number.
Press the Enter Button (#13) to confirm your selection.
The unit will begin scanning for an active main channel. If a transmission is detected, the
Rx and RSSI icons will appear in the LCD Panel (#8).
To turn off the auto channel scan feature in the standby mode, simply press the Function
Button (#12) once.
3.4-4 DUAL WATCH SCAN MODE
This feature allows you to monitor two different channels at the same time. If you pre-set
any priority channel other than the current channel in use, the pre-set channel will be
scanned every 0.5 second and signals you when a call is received.
To access the Dual Watch Scan menu,
Press the Function Button (#12) until the dual watch icon blinks and dW
appears in the LCD Panel (#8).
Press the Up Button (#10) or the Down Button (#11) to select the desired
channel number you wish to closely monitor.
Press the Enter Button (#13) to confirm your selection.
To turn off the dual watch feature in the standby mode, simply press the
Function Button (#12) once.
3.4-5 VOX SELECTION MODE
The Voice Activated Transmission (VOX) function allows your voice to activate
transmission automatically when the Communicator is used with an optional handsfree
mic/headset, or even with the built- in Microphone.tton (#4) without using the PTT button.
To access the VOX Selection menu,
Press the Function Button (#12) until the VOX icon blinks and UO appears in the LCD
Panel (#8).
Press the Up Button (#10) or the Down Button (#11) to select from high, low or off. High or
low setting determines VOX response sensitivity.
Press the Enter Button (#13) to confirm your selection.
To turn off the VOX feature, enter the VOX selection mode and then select Off.
To Next Page
Loading...
