EasyManua.ls Logo

Albrecht Tectalk - SAFETY PRECAUTIONS AND ACCESSORIES; Hazardous Areas and Blasting Operations

Albrecht Tectalk
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
Blasting Caps and Areas
To avoid possible interference with blasting operations, turn your radio off near electrical blasting
caps or in a “blasting area” or in areas posted:” Turn off 2-way radio”. Obey all signs and
instructions.
Note:
Areas with potentially explosive atmospheres are often, but not always, clearly marked.
They include fuelling areas such as below deck on boats, fuel or chemical transfer or storage
facilities; areas where the air contains chemicals or particles, such as grain, dust, or metal
powders; and any other area where you would normally be advised to turn off your vehicle engine.
Accessory Desktop Charger
After removing the charger base and power supply from the packaging, plug the power supplys
DC connector into the jack on the back of the base.
To charge a battery, simply place the radio into the front charging well. Cycle lasts up to 10 hours.
As option, a 12 V DC cable for Car use is available. This will allow charging the radio from car 12
V supply.
European 2 years warranty
The distributor, dealer or retail shop warrants to the original retail purchaser of this product that should this
product or any part of it, under normal use and conditions, be proven defective in material or workmanship
within 2 years from the date of original purchase, such defect(s) will be repaired or replaced with new or
reconditioned product (at the company's option) without charge for parts and repair labor. To obtain repair
or replacement within the terms of this warranty, the product is to be delivered with proof of warranty
coverage (e.g. dated bill of sale), specification of defect(s), to the distributor, dealer or his authorized
repair center.
The Company disclaims liability for communications range of this product. The warranty does not apply to
any product or part there of which, in the opinion of the company, has suffered or been damaged through
alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of
the factory serial number/bar code label(s). The warranty does not apply to accessory parts or problems
caused through not authorized or not recommended accessories like of the units like batteries, external
power supplies and over voltage caused through external power supplies, light bulbs, broken antennas,
broken swivel belt clips, broken or damaged acrylic glass windows and cabinet parts.
Please contact the dealer or person where You have purchased Your Tectalk.
D.C Power Jack
Charging Well

Other manuals for Albrecht Tectalk

Related product manuals