Albrecht Tectalk - CORE BUTTON FUNCTIONS; PTT, Volume, Function, and Monitor Buttons

5
number or number to frequency in about 1 second.
PUSH-TO-TALK (PTT) BUTTON (#4)
1. Press it firmly and speak into the Built-in Microphone (#9) to transmit. The red Tx LED
Indicator at the right side of the LCD Panel (#8) will light.
2. Release it to revert to standby mode. When an incoming call is received, the green Rx LED
Indicator on the left side of the LCD Panel (#8) will light.
3. 2-Way Call Ringer: Press the PTT Button twice quickly to call another party on the same
channel. The word “CALL” and the Tx icon will appear in the display. The user selected call
ringer melody will play (see page 6 to change call melody). The Call melody can be switched
off with the same menu step to avoid accidential activation.
VOLUME CONTROL (#10
(
55
)
& #11
(
66
)
)
In the standby mode, adjust volume to a comfortable level by pressing the
UP
(#10
5
) & the
DOWN
button (#11
6
) and adjusting the volume control at the same time.
UP
BUTTON (#10)
(
5
)
•
Short Touch
In the standby mode, press this button briefly to move to the next higher main volume level.
In the function edit mode, press briefly to shift from the current option in each submenu to the
next option in the same submenu.
•
Long Touch
Pressing this button for more than 1.5 seconds will allow you to navigate at a more rapid rate
through different volume level in the standby mode or through different menus in the function
edit mode.
DOWN
BUTTON (#11)
(
6
)
•
Short Touch
In the standby mode, press this button briefly to move to the previous lower main volume
level.
In the function edit mode, press briefly to shift from the current option in each submenu to the
previous option in the same submenu.
•
Long Touch
Pressing this button for more than 1.5 seconds will allow you to navigate at a more rapid rate
through different volume level in the standby mode or through different menus in the function
edit mode.
FUNCTION
BUTTON (#12)
(
F
)
•
Short Touch
Press this button briefly to enter function edit mode in standby mode.
•
Long Touch
Press for longer than 1.5 seconds to activate or deactivate the KEY LOCK in the standby
mode. Please note all buttons will be disabled except the Monitor Button (#2) and PTT
Button (#4) will remain fully operational (see menu description to activate and disable the
auto key lock function).
MONITOR BUTTON (#2) (=disable automatic squelch)
•
Press it to check activity on the current channel before you try to transmit.