— 32 —
ALC CONNECT APP STATUS SCREEN
Basic Operation
V
At the Camera’s Edit window, you
can also tap then enter the Admin
Password to enter the Advanced
settings as described on the next
page.
U
Tap next to the Camera to enter
the Camera’s Edit window, which will
allow you to change the Name, DID,
Security Code and Location.
y
Tap to enter the respective
device’s Edit window, which will allow
you to set the following:
Siren: Name and Location. You can
also set the Siren volume.
Door/Window Sensor: Name and
Location. You can also set the Entry
Delay Time to 30 seconds before the
sensor activates.
Remote Control: Name and
Location.
Power Switch: Name and Location.
You can also set the Auto Off Time
(when set with a scenario).
Motion Detector: Name and
Location.
Camera: See the following page.
Tap X to delete the device.
Note:
Default admin password is 123456. This
password is needed if you need to change any
advanced setting.
To Next Page
Loading...